Can only select one input from my audio interface

[somebodyrich]

Hello,
I am using an Artcessories USB phono plus as the audio interface for my mac laptop. I have used it before to make a stereo recording in Amadeus Pro. Now, for some reason when I open the input dialog box, I am only allowed to select channel 1 as an input, and even if I am recording to a new stereo track it comes out as a dual mono, putting the source material from only input 1 on both tracks.........
If I select input from the internal mic I can select input 1 or 2, but that is only a single channel device....!
I'd appreciate any advice.
Best wishes to one and all,
Somebodyrich

[Martin Hairer]

I am using an Artcessories USB phono plus as the audio interface for
my mac laptop. I have used it before to make a stereo recording in
Amadeus Pro. Now, for some reason when I open the input dialog box,
I am only allowed to select channel 1 as an input, and even if I am
recording to a new stereo track it comes out as a dual mono, putting
the source material from only input 1 on both tracks.........

Strange. Does only one channel show up if you click on "Advanced
Settings" in the Amadeus Pro sound preferences? What about the
"Audio / Midi Setup" utility? Regards,

Martin

HairerSoft
http://www.hairersoft.com/


_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list