Audio Units not showing in Batch
Moderator: Martin Hairer
-
- Posts: 2
- Joined: Wed Aug 14, 2013 11:10 pm
- Location: Hesperia, CA
- Contact:
Audio Units not showing in Batch
Trying to make a batch process that will apply a gate using the Dynamics Processor. When I mouse over Audio Units in the Add Action menu the Audio Units don't show. I recently upgraded to version 2. Don't think this happened before that.
Any fixes, or just waiting for an update?
Thanks,
Tim
- Martin Hairer
- Site Admin
- Posts: 1976
- Joined: Wed Nov 08, 2006 11:49 am
- Contact:
Audio Units not showing in Batch
Maybe the Audio Unit is 32-bit only? Regards,
Martin
--
HairerSoft
http://www.hairersoft.com/
_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
Martin
--
HairerSoft
http://www.hairersoft.com/
_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
-
- Posts: 13
- Joined: Tue Sep 08, 2009 7:26 pm
- Martin Hairer
- Site Admin
- Posts: 1976
- Joined: Wed Nov 08, 2006 11:49 am
- Contact:
Audio Units not showing in Batch
You can open Amadeus Pro in 32 bit mode by selecting it in the Finder, typing command-I (Get Info) and activating the corresponding checkbox. Regards,Forgive my ignorance, are there any ways around this?
Martin
--
HairerSoft
http://www.hairersoft.com/
_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list