Mailing ListMailing List   FAQFAQ   SearchSearch   MemberlistMemberlist   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Getting an error when trying to reply the matrix reverb audi

 
Post new topic   Reply to topic    www.hairersoft.com Forum Index -> Discussion
View previous topic :: View next topic  
Author Message
Martin Hairer
Site Admin


Joined: 08 Nov 2006
Posts: 1615

PostPosted: Wed Dec 21, 2011 10:16 am    Post subject: Getting an error when trying to reply the matrix reverb audi Reply with quote

Quote:
Hi, I'm trying to put some reverb onto a track here, and when I try to apply it, I'm getting an error that says that this unit may not be able to handle tracks with two channels, try converting to mono. I do that to the track, and then try to apply the effect again, and I get an error that says the reverse, that it can't be applied to tracks with one channel, and to try converting to stereo. ANy help on this would be appreciated.

Could you tell us exactly what steps you are following and what the characteristics of your sound file are so I can try to reproduce this? Thanks,

Martin

--
HairerSoft
http://www.hairersoft.com/



_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Martin Hairer
Site Admin


Joined: 08 Nov 2006
Posts: 1615

PostPosted: Wed Dec 21, 2011 11:24 am    Post subject: Getting an error when trying to reply the matrix reverb audi Reply with quote

Most reverb effects work only on stereo tracks. If your track is stereo, then make sure that you also have both channels selected. If only one channel is selected, it behaves as if the track was mono, since the effect would only be applied to the selected channel.
Regards,

Martin

--
HairerSoft
http://www.hairersoft.com/



_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Martin Hairer
Site Admin


Joined: 08 Nov 2006
Posts: 1615

PostPosted: Wed Dec 21, 2011 11:53 am    Post subject: Getting an error when trying to reply the matrix reverb audi Reply with quote

Quote:
Ok, how do I select channels via the keyboard then?

Up and down arrows. Think of the left channel as being at the "top" and the right channel at the "bottom". So if the left channel is selected and you hit the down arrow, both channels will be selected. If you hit the down arrow again, only the right channel will be selected.

The only subtlety is that if you hit the up / down arrows while some sound is being played back, it will change the playback speed instead. Regards,

Martin

--
HairerSoft
http://www.hairersoft.com/



_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    www.hairersoft.com Forum Index -> Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group