Making a Pre-Recorded Fade Out Into Uniform Volume?

Discussion forum for Amadeus users

Moderator: Martin Hairer

Post Reply
mbdrums
Posts: 30
Joined: Wed Jan 30, 2013 3:02 pm
Location: Philadelphia Area
Contact:

Making a Pre-Recorded Fade Out Into Uniform Volume?

Post by mbdrums »

Does anybody have any quick solutions as to how you can take a Pre-Recorded Fade Out and make it so that particular section is of a Uniform Volume (with NO Fade Out)?

I can do it manually taking one little piece at a time, but was trying to avoid that - very time consuming :-)

Many thanks in advance!

~ Mark
Official Voting Member - The GRAMMYs
Professor of Music/Percussion - Drexel University
President - National Association of Rudimental Drummers (N.A.R.D)

CDJonah_alt
Posts: 379
Joined: Thu Mar 15, 2007 3:57 pm

Making a Pre-Recorded Fade Out Into Uniform Volume?

Post by CDJonah_alt »

I can't think of a way to do the whole thing but you could take a
section, amplify it to maximum and then use the envelope command to
lower the initial part to match the final part. As you can use markers
and the envelope command has values, you may well be able to do a
passable job. (of course at the end, you are dealing with not much
signal so who knows what you will get.

Chuck

On 8/19/16, 8:55 AM, mbdrums wrote:
Does anybody have any quick solutions as to how you can take a Pre-Recorded Fade Out and make it so that particular section is of a Uniform Volume (with NO Fade Out)?

I can do it manually taking one little piece at a time, but was trying to avoid that - very time consuming :-)

Many thanks in advance!

~ Mark

------------------------
Official Voting Member - The GRAMMYs
Professor of Music/Percussion - Drexel University
President - National Association of Rudimental Drummers (N.A.R.D)



Post Reply