Move tracks to center or slightly to side
Moderator: Martin Hairer
-
- Posts: 6
- Joined: Fri May 13, 2011 1:47 am
Move tracks to center or slightly to side
Apologies if this has been covered, but I can’t find it. (Perhaps I used the wrong search terms?) I have 4 tracks, 2 of which are vocals. I would like to move one to the center and one slightly to the left. I would also like to take a piece of track 3 (drum) move it let and then back right.
How do I do this?
Thank you in advance,
Doug
How do I do this?
Thank you in advance,
Doug
Move tracks to center or slightly to side
response deleted
Last edited by craig on Sun Dec 25, 2011 7:30 pm, edited 1 time in total.
-
- Posts: 6
- Joined: Fri May 13, 2011 1:47 am
Thank you for your reply. I am using version 2.0. Perhaps a fuller explanation would clarify.
Track 1 – female vocal
Track 2 – male vocal
Track 3 – drums
Track 4 – guitar
If you were in the audience facing the group, the female voice is to the left, the male to the right, drums and guitar behind.
I would like the female voice to be placed just left of center, the male voice just right of center, drums left of the female voice, guitar to the right of the male voice. However, I do not want any of them fully left or fully right.
As for track 3 (drums) I have a section of that track I want fully left and a section that is fully right.
In other audio editing software I am used to fader sliders, knobs, or panning envelops. Perhaps I am just missing something?
Again, thanks in advance for any assistance.
Track 1 – female vocal
Track 2 – male vocal
Track 3 – drums
Track 4 – guitar
If you were in the audience facing the group, the female voice is to the left, the male to the right, drums and guitar behind.
I would like the female voice to be placed just left of center, the male voice just right of center, drums left of the female voice, guitar to the right of the male voice. However, I do not want any of them fully left or fully right.
As for track 3 (drums) I have a section of that track I want fully left and a section that is fully right.
In other audio editing software I am used to fader sliders, knobs, or panning envelops. Perhaps I am just missing something?
Again, thanks in advance for any assistance.
Move tracks to center or slightly to side
My first response was off base since I misunderstood the problem. At
the risk of being unhelpful again, but since no one else that might
know better has responded, I will offer the following suggestion
(again for AP 1.5 but presumably AP 2 has something similar):
If the track is currently mono, convert to stereo using Sound->Convert
Track to Stereo
then adjust the balance using Effects->Stereo Utilities->Balance
For the drum track you would just select part of the track for each
balance adjustment and perhaps use Effects->Fading->Fade In/Out
separately on the left and right channels to get a smooth transition.
On Dec 25, 2011, at 12:04 PM, DougWheeler wrote:
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
the risk of being unhelpful again, but since no one else that might
know better has responded, I will offer the following suggestion
(again for AP 1.5 but presumably AP 2 has something similar):
If the track is currently mono, convert to stereo using Sound->Convert
Track to Stereo
then adjust the balance using Effects->Stereo Utilities->Balance
For the drum track you would just select part of the track for each
balance adjustment and perhaps use Effects->Fading->Fade In/Out
separately on the left and right channels to get a smooth transition.
On Dec 25, 2011, at 12:04 PM, DougWheeler wrote:
_______________________________________________Thank you for your reply. I am using version 2.0. Perhaps a fuller
explanation would clarify.
Track 1 – female vocal
Track 2 – male vocal
Track 3 – drums
Track 4 – guitar
If you were in the audience facing the group, the female voice is to
the left, the male to the right, drums and guitar behind.
I would like the female voice to be placed just left of center, the
male voice just right of center, drums left of the female voice,
guitar to the right of the male voice. However, I do not want any of
them fully left or fully right.
As for track 3 (drums) I have a section of that track I want fully
left and a section that is fully right.
In other audio editing software I am used to fader sliders, knobs,
or panning envelops. Perhaps I am just missing something?
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list
-
- Posts: 6
- Joined: Fri May 13, 2011 1:47 am
-
- Posts: 6
- Joined: Fri May 13, 2011 1:47 am