loop (cycle) playback

Discussion forum for Amadeus users

Moderator: Martin Hairer

Post Reply
progkeys
Posts: 4
Joined: Wed May 08, 2013 3:23 pm

loop (cycle) playback

Post by progkeys »

I can't figure out how to make Amadeus Pro continuously loop over a selection or file. The loop-fade feature is great, but I need to be able to hear what it's going to sound like. Is this possible? It seems like an oversight because every wave editor I've ever used does it (often by default).

Gerard Bik
Posts: 353
Joined: Fri Nov 10, 2006 9:04 pm

loop (cycle) playback

Post by Gerard Bik »

Try the checkbox called "Loop playback" in the lower left corner of the window.


--
______________________ _
Gerard Bik grafische vormgeving
Van Aerssenstraat 263
2582 JM Den Haag
070 3554081

Website: http://www.biknewz.nl
IEDP gecertificeerd
_______________________________________________
Amadeus forum mailing list
Unsubscribe / change settings at http://two.pairlist.net/mailman/listinfo/forum_list

progkeys
Posts: 4
Joined: Wed May 08, 2013 3:23 pm

Post by progkeys »

Thanks, I actually managed to find it after I posted. You may want to consider adding it to the user's manual. When I searched for "loop" or "cycle" in the manual and didn't find anything, I began to think the feature wasn't there at all, especially as the loop playback checkbox isn't anywhere near the transport controls in the UI.

I don't want to sound like I'm complaining. These are just suggestions on how you could make this already terrific piece of software a little better. Thanks so much for writing and supporting it.

Post Reply